Calculating kg CO2e from diverted biomass
How to turn the tonnes of fish by-products kept out of landfill into the kg CO2e avoided: the core formula, three steps that can be repeated for any by-product stream, a worked example, where to find factors and a checklist before publishing a figure.
Avoided kg CO2e = tonnes kept out of landfill × the landfill factor: what landfill would have emitted. For 100 t of fish by-products kept out of landfill, that is about 70 t CO2e with UK government factors, or 63–126 t with IPCC 2006 defaults, depending on landfill gas capture. The three steps below can be repeated for any by-product stream; real-world examples are in Biomass diversion CO2e case studies.
Indicative values: these figures do not replace an exhaustive life cycle assessment (LCA).
Estimate yours: the CO2e estimator runs these steps for the tonnes you keep out of landfill, with the factors in this guide.
The core formula
The saving is what landfill would have emitted from the tonnes you keep out of it. The new use’s own emissions, from processing energy and transport, are not counted here: a full life cycle assessment would add them.
Eavoided = M × EFlandfill
- M: wet tonnes diverted from landfill (Step 2).
- EF landfill: kg CO2e per tonne if landfilled, mostly methane (Step 3).
With factors in kg CO2e per tonne, the result is in kg CO2e; divide by 1,000 for tonnes.
The saving is what landfill would have emitted
Two routes for the same by-product tonnes · landfill vs new use
Define the baseline and boundary
Claim only against what would really have happened to each stream. The baseline sets the size of the saving more than any factor does.
- Baseline per stream: for heads, frames, viscera, skins and trimmings, record where each goes today and where it would go without the project. Options include landfill, rendering, silage, fishmeal, compost or digestion. Use disposal records, contracts or waste invoices.
- Landfill factor for landfill-bound tonnes only: tonnes already sold to fishmeal or feed have a different, much smaller baseline. Moving them from meal to collagen is a value story, not a landfill saving. Disposal at sea needs its own assessment; a landfill factor does not apply.
- Boundary: the landfill route the by-product would have taken, from the point it leaves processing.
- Period and units: usually one year, wet tonnes and kg CO2e, with the GWP set stated.
WBCSD’s avoided-emissions guidance (v2.0, July 2025) explains how to set the reference scenario.
Measure the mass
Every factor below is per tonne, so the input must be wet tonnes, not cubic meters.
- Weigh where you can: weighbridge tickets, tub counts × average tub weight, or plant yields (round weight × the by-product share from your own yield records).
- Volume only: multiply cubic meters by a measured bulk density (kg per m³) for that stream as it is stored. Loose and packed material differ a lot. EPA’s volume-to-weight conversion factors give typical densities for waste materials.
- Wet or dry: the IPCC defaults in Step 3 are per wet tonne, while Verra VM0046 uses defaults per tonne of dry matter. Never mix the two.
Choose the landfill factor
Use a published per-tonne factor for a quick, citable number, or the IPCC equation when you know the site’s gas capture. The choice can change the result more than threefold, as the chart shows.
Option A: published factors. The UK government conversion factors (Waste disposal tab, food and drink waste) and US EPA WARM (food waste) both give a lifetime figure per tonne, with their own country’s landfill gas capture built in.
Option B: the IPCC equation. Calculate the methane from the waste’s degradable carbon, then convert it with methane’s global warming potential (GWP):
CH4 = W × DOC × DOCf × MCF × F × 16⁄12 × (1 − R) × (1 − OX)
kg CO2e = CH4 × GWPCH4
| Parameter | Meaning | IPCC default | Source |
|---|---|---|---|
| W | Wet mass landfilled (kg) | Your data | Step 2 |
| DOC | Degradable organic carbon in food waste | 0.15 wet (0.38 dry) | CDM Tool 04 |
| DOCf | Share of that carbon that decomposes | 0.5 for mixed waste (2006); 0.7 for food waste (2019 Refinement) | IPCC 2006, Vol 5 Ch 3 |
| MCF | Methane correction factor | 1.0 managed anaerobic; 0.5 semi-aerobic; 0.8 unmanaged deep; 0.4 unmanaged shallow; 0.6 uncategorized | IPCC Table 3.1 |
| F | Methane share of landfill gas | 0.5 | IPCC Ch 3 |
| R | Share of methane captured and flared or used | Site data; 0 if none | Landfill operator |
| OX | Methane oxidized in the cover soil | 0.1 managed and covered; 0 otherwise | IPCC Table 3.2 |
| GWP | Warming of 1 kg CH4 over 100 years, in kg CO2 | 28 (AR5) or 27.0 (AR6, non-fossil) | GHG Protocol |
The IPCC model spreads this release over years; food waste has a half-life of about 4 years in wet temperate or boreal climates. Per-tonne factors count the lifetime total. Fish by-products differ from average food waste, so use a lab DOC value if you have one. For Icelandic sites, the national inventory documents the parameters used (UNFCCC 2026 submissions).
Landfill factors for food waste range from about 550 to 1,760 kg CO2e a tonne
kg CO2e per wet tonne landfilled, lifetime total. Blue = the factor used in the worked example.
| Published factors | |
|---|---|
| US EPA WARM v16 | 551 0.50 t CO2e per short ton of food waste |
| UK government 2026 | 700 700.3 kg CO2e per tonne of food and drink waste: the factor used in the worked example |
| EPA figure in Great Lakes report | 924 838 t CO2e per 907 t, the EPA figure quoted in the 100% Great Lakes Fish report |
| IPCC calculation (GWP 28) | |
| 2006 defaults, 50% gas capture | 630 DOC 0.15, DOCf 0.5, MCF 1, F 0.5, OX 0.1, half the methane captured |
| 2019 food-waste DOCf, 50% capture | 882 DOCf 0.7 in place of 0.5, half the methane captured |
| 2006 defaults, no gas capture | 1,260 DOC 0.15, DOCf 0.5, MCF 1, F 0.5, OX 0.1, no methane captured |
| 2019 food-waste DOCf, no capture | 1,764 DOCf 0.7 in place of 0.5, no methane captured |
Gas capture halves the IPCC result; the 2019 food-waste DOCf (0.7 instead of 0.5) raises it by 40%.
Published factors already assume some gas capture; the IPCC rows show how much capture and the DOCf choice move the result.
- GWP set: use one set throughout and state it. AR5 (methane 28) is still widely used in published factor sets; AR6 gives 27.0 for biogenic methane and 29.8 for fossil methane (GHG Protocol table).
- Biogenic CO2: CO2 released as by-products decompose or burn is biogenic and is not counted. Only methane and nitrous oxide count.
Worked example: 100 t of fish by-products
Keeping 100 t of landfill-bound by-products out of landfill avoids about 70 t CO2e with UK factors, or 63–126 t with IPCC 2006 defaults.
- Mass: 100 t of wet by-product, all landfilled today, confirmed from waste invoices.
- IPCC landfill factor per tonne: 1,000 kg × 0.15 × 0.5 × 1.0 × 0.5 × 16/12 = 50 kg of methane generated. With no gas capture and OX 0.1, 45 kg is released: 45 × 28 = 1,260 kg CO2e. With 50% capture, 22.5 kg is released: 630 kg CO2e.
- Avoided: M × EF landfill.
| Approach | Landfill (kg CO2e/t) | Avoided for 100 t (t CO2e) |
|---|---|---|
| UK government factors | 700 | 70 |
| IPCC defaults, no gas capture | 1,260 | 126 |
| IPCC defaults, 50% gas capture | 630 | 63 |
GWP 28 (AR5); figures rounded. These are the landfill emissions avoided: the new use’s own energy, fuel and transport are not subtracted, so a full life cycle assessment would give a lower net figure.
With the 2019 Refinement’s food-waste DOCf of 0.7 instead of 0.5, both IPCC rows rise by 40%, to roughly 176 t (no gas capture) and 88 t (50% capture) for 100 t.
Where to find factors
Pick one main factor set, cite its year, and use the others as cross-checks.
| Source | What it gives | Use it when |
|---|---|---|
| UK government conversion factors 2026 | kg CO2e per tonne for landfill, composting, digestion and incineration; fuel and freight factors | You want a citable European set, updated every year |
| US EPA WARM v16 | t CO2e per short ton by material and route, including landfill | You want a US landfill factor |
| IPCC 2006 Guidelines, Vol 5 Ch 3 and 2019 Refinement | Landfill methane equations and default values | You know the site’s gas capture or want transparent first principles |
| UN CDM Tool 04 | Year-by-year landfill methane model (first-order decay) | You need project-grade or credit-grade numbers |
| Iceland’s national inventory (UNFCCC 2026 submissions) | Parameters used for Icelandic landfills | You need Iceland-specific landfill assumptions |
| GHG Protocol GWP table | GWP values from AR4, AR5 and AR6 | Converting methane and nitrous oxide to CO2e |
| EPA volume-to-weight factors | Typical bulk densities of waste materials | You only have volumes |
Checklist before publishing a figure
The most common error is applying a landfill factor to by-product that was never going to landfill.
- Baseline evidenced per stream; only landfill-bound tonnes get the landfill factor
- Mass in wet tonnes, from weights rather than guessed volumes
- One factor set and year cited; metric tonnes and short tons not mixed
- Landfill gas capture at the baseline site known, or stated as an assumption
- GWP set stated (AR5 or AR6) and used throughout; biogenic CO2 excluded
- A range shown (for example low and high gas capture) rather than one precise-looking number
- Avoided emissions reported separately from your own footprint, never subtracted from it
- No double counting with a customer’s or partner’s claim
- Stated as indicative: the landfill emissions avoided, not an exhaustive life cycle assessment
Sources
- UK government GHG conversion factors 2026, published 11 June 2026
- UK 2026 factor, food and drink waste to landfill: 700.3 kg CO2e/t (via Climatiq)
- IPCC 2006 Guidelines, Vol 5 Ch 3: Solid Waste Disposal
- IPCC 2019 Refinement, Vol 5 Ch 3: Solid Waste Disposal
- UN CDM Tool 04 v5.1.0: emissions from solid waste disposal sites
- GHG Protocol: Global Warming Potential values, August 2024
- US EPA WARM documentation and WARM v16 management practices chapters
- WBCSD Guidance on Avoided Emissions v2.0, July 2025
- US EPA Volume-to-Weight Conversion Factors, April 2016
- Iceland 2026 National Inventory Document (UNFCCC)
- 100% Great Lakes Fish: Socio-Economic and Environmental Analysis
Estimate yours: the CO2e estimator runs these steps for your own tonnes. The six case studies show how others have done it.